Friday, April 22, 2011

I made this rubix cube. It didn't take long, I used the array command to make this. I learned how to put color on each face.

Friday, April 1, 2011

Screwdriver

This is just a rough sketch of a screw driver. I dont have it dimmensioned or anything, this is my best guess at the size of all parts.

Wednesday, March 23, 2011

Bridge

I made this bridge using the frame generator. It is 24 inches long 8 inches wide and high. I used 1/4*1/4 tubing. Then I used the frame analysis and this is the pictur of the frame analysis.

Friday, March 18, 2011

Mancala Board

I made this mancala board from the AutoCAD 05' book. I used the mirror tool instead of making each individual hole. This board is made of cherry.

Wednesday, March 2, 2011

Pacman Cookie Cutter Cont.

This is an under side view of the cookie cutter.

Pacman Cookie Cutter

I followed parameters from the AutoCAD site. This is a cookie cutter that is 1mm thick on the cutting edge. The handle is 15mm wide 30mm long and 10mm tall.

Tuesday, February 22, 2011

Arm

I took this out of the AutoCAD 2005 book on page 646. This is a cast iron arm. It took me about a day and a half to make.