I made this rubix cube. It didn't take long, I used the array command to make this. I learned how to put color on each face.

Screwdriver

This is just a rough sketch of a screw driver. I dont have it dimmensioned or anything, this is my best guess at the size of all parts.

Bridge

I made this bridge using the frame generator. It is 24 inches long 8 inches wide and high. I used 1/4*1/4 tubing. Then I used the frame analysis and this is the pictur of the frame analysis.

Mancala Board

I made this mancala board from the AutoCAD 05' book. I used the mirror tool instead of making each individual hole. This board is made of cherry.

Pacman Cookie Cutter Cont.

This is an under side view of the cookie cutter.

Pacman Cookie Cutter

I followed parameters from the AutoCAD site. This is a cookie cutter that is 1mm thick on the cutting edge. The handle is 15mm wide 30mm long and 10mm tall.

Arm

I took this out of the AutoCAD 2005 book on page 646. This is a cast iron arm. It took me about a day and a half to make.

AutoCad book

I made this drawing out of the AutoCad 2005 book as well. It was a simple drawing. I am not sure what this piece is or what it does.

I made this from the AutoCad 2005 book on page 551. I made this by making a cross section and revolving it. In the book there is more to this assembly but this is what I have so far.

bowling pin continued

I copied and pasted the bowling pin that I made in Inventor into paint and customized this pin. It has nothing to do with Inventor but it was fun.

Bowling Pin

I found a picture similar to this on the internet and thought it would be fun to try and draw the bowling pin in inventor. I drew this by making a plane at each of the dimensions that are going accross and making a different sized circle, then I lofted all of the circles together. I wish I could figure out how to dimension how high up from the bottom each measurment is.

Updated go kart

Since the last post of my go kart I have added a steering wheel and back axle along with the two plates. The back plate is what I will mount the engine on and the front plate is so your feet don't go through the ground.

Seat

This is a generic seat I made just for the drawing. For my actual go kart I will try to find a seat about this size and put it on to the go kart.

This is another part of the steering system that will connect the spindle to the steering wheel. The top right hole will be welded to the rod comming off of the steering wheel, so when you turn the wheel it will push and pull the rods to turn the spindles, in turn turning the wheels.

Spindle

This is the spindle, the wheel connects to the screw that is going out to the left. This will connect to the steering wheel with a couple of other rods to steer my go kart.

My Go-Kart

For the past week or so I have been working on this design for my senior project. Most of the time has been spent on trying to get an accurate picture of the steering system that I will use.